The oil tank installation isn’t complex if you have the correct procedure and proper equipment. All you need to do is follow our step-by-step guide, and we promise the process will be a breeze for you. It’s crucial to take safety precautions, though. With all of the hazardous chemicals in oil, not wearing the appropriate attire could prove fatal.
Prepare Your Work Area
If possible, try working outside since this project usually involves a lot of mess and stench. If this isn’t possible, make sure you wear your gloves and face mask well before starting to prevent any direct contact with these toxic substances. Also, keep in mind that some of the substances inside your oil tank are inflammable, so you must work carefully and be aware of fire hazards. Ensure the place for oil tank installation westchester county ny is safe.
Drain the Oil Took care of all the potential risks involved? Then it’s Time to start draining out that thick red liquid! Position one end of your hose on top of the overflow tube (the small plastic pipe sticking out of the oil tank). The other end should be placed at least 15 feet away from any open flame or source of heat.
Remove the cap, let the oil drain into your storage container for a few minutes, and then replace the cap to avoid spilling or splashing. If your tank isn’t big enough to store all that oil at once, then it might be safer to double-check if you can disconnect your pipe from the overflow tube.
It would be best if you also considered securing the pipe, so there’s no chance of clogging or rupturing when draining out heavy volumes of liquids. The last thing you want is an oil spill in your storage container.
Cleaning Time You know how some people are prone to getting burrs stuck on their socks? It’s pretty much the same principle here. The inside surface of your fuel tank is going to be covered with a sticky residue. This film will reduce the efficiency of your homemade oil filter, so you must clean it off before installing the new equipment.
Use a brush and solvent to scrub away from any stubborn bits of dirt clinging on. I used fiberglass fiber brushes for this purpose since they’re inexpensive, don’t rip out quickly, and are gentle enough to use on curved surfaces. You can add more solvents or water if needed. There shouldn’t be any fumes coming from your drilling site when cleaning, but make sure all the vents in your room are left open regardless.